While the A086 cage worked pretty well for me once I got a larger base ring, there was one thing I didn’t like. The cage was a little over an inch too long for me. Also, the gap was a little too wide and as a result I had ball slippage a couple of times. Since it will still be several more weeks before I can expect to receive my Mature Metal Watchful Mistress cage, with LJ’s approval I ordered another cage to use during the interim. About a week later, I received the Man Trap (MT4889) from California vendor Koalaswim.
Intro
I was impressed with the Man Trap right out of the box. It seemed a quality build, constructed of surgical grade stainless steel. All cage interior and exterior surfaces were completely smooth. The gap was much narrower than that of the A086 I’d been wearing. And the gap was uniform all the way around. This was accomplished by setting the center locking pin about five degrees below horizontal. I was confident this device would not allow for slippage and I couldn’t wait to try it on.
However, after putting it on I immediately discovered that the narrow gap was too narrow for my high and tight scrotum. Things soon became unbearably uncomfortable. But, the cage itself fit so well I wasn’t about to give up on it so quickly. I took the base ring down to my shop, put it into a vice, and heated it with a torch. I then carefully bent the center locking post upwards to remove the five degree downward attitude. That opened up the gap, but still left it narrower than that of the A086. I put the base ring and cage back on after the adjustment and the fit was perfect.
I feel the adjustment I made would be necessary for guys with high and tight scrotum like mine to wear this device comfortably. But, for those with a longer scrotum and lower hanging balls the gap would probably be fine as it comes from the manufacturer. Fortunately, because of its high-quality construction, the adjustment is easily and safely made.
Meet the Man Trap
The Man Trap is another simple ball-trapping device is comprised of three parts.
1. Base ring.
2. Open-style vented stainless steel cage.
3. Brass padlock with two keys.
Base rings are available in the three standard off the shelf sizes – 2 in. (50mm), 1.75 in. (45mm), or 1.50 in. (40mm).
Fit
Man Trap doing it’s thing
This cage is 2-inches long and 1-1/2 inches wide. The length is perfect for me, exactly the same length I ordered for my custom-made Mature Metal cage. This eliminates any extra room for attempted erections to get started and also makes peeing a much less risky proposition. I still sit to pee to err on the side of caution, but with my urethral opening properly aligned with the urination hole at the end of the cage, I have been able to pee normally while standing with little or no mess. With an average size penis, I find the cage snug, but not tight. I’m easily able to insert my flaccid penis fully into the cage without use of the stocking method. Once the cage is mated with the base ring and locked, it feels very secure.
Comfort
This is by far the most comfortable device I’ve worn since beginning with chastity. While steel, it is surprisingly lightweight. That means the base ring stays close to my body. Initially, I was a bit concerned the opening to the cage might cause chafing where it presses tightly against the scrotum. The reason is that the opening is not an actual ring, but a ring formed of flat steel and therefore has a thinner edge than other devices I’ve tried. But, happily I have had no chafing problems at all. It’s been a non-issue.
Security
As mentioned, I find the device very secure. I’m confident It would be very difficult, not to mention painful if I tried to pull out of it while locked. Of course, we accept that no ball-trapping device is one-hundred percent secure unless combined with a piercing. Where there is a will, there is almost always a way. Still, for someone serious about experiencing chastity who has no intention of attempting to defeat the device, I think this device is about as secure as it gets.
Hygiene
Thanks to the open-design, I’ve found the Man Trap simple to keep clean. Since urination is less problematic, I’ve not experienced any funky smells between cleanings. LJ generally requires me to go a week between unlocking for cleaning and maintenance so hygiene is always an important consideration for me.
Other impressions
Beyond the adjustment I found necessary to accommodate my high and tight scrotum, I can’t find anything to dislike about this device. It’s well made and comfortable to wear. Koalaswim describes the Man Trap as part of its exclusive “Handmade” collection. I’m unsure what that means exactly, whether it means they manufacture it in the U.S. or not. All, I can say it doesn’t look like any made in China device I’m familiar with. The standard of quality suggests it isn’t made in China. I’ll be happily wearing this device until my permanent custom-made device is delivered. It’s also great to know I have a well made, great fitting device to use should I ever need to send my Mature Metal device back for any adjustments.
Recommendation
For a guy looking for a well made, mid-range chastity device and for whom a 2-inch cage length is appropriate, I see no reason not to recommend this cage. Just remember if you have a high and tight scrotum you will probably have to make the minor adjustment I’ve described. At the time I published this review, it was available from Koalaswim for $69.00 plus shipping. It’s far superior to any of the cheap, made in China devices I’ve tried personally and I’ve had great experiences with Koalaswim both times I’ve made purchases from them.
Only my own opinions are expressed in this review. I purchased the Man Trap using my own funds, and I have no affiliation with Koalaswim.